LCD Setup

Connector Panel

Setting up a single LCD cell is as simple as connecting the cables to the computer running the Cornerstone software.

  • Connectors:
    The image above details the basic connections to make with regard to the connector panel.

  • Camera:
    The camera inside the Multitouch Cell needs to be connected to the computer using an FW800 cable. Of the two FW800 connectors on the connector panel, only the left (when looking from behind the box) will be used. Note that if you are not certain that you have connected the correct FW800 connector, you can use the FireView application that comes with Cornerstone to verify this.

  • FireView:
    Connect one of the FW800 ports to the computer and run: FireView --scanbus
    If the camera is detected, you have the correct connector. If no cameras are found, switch connectors and run FireView again.

  • HDMI:
    The Multitouch Cell must be connected to the graphics card of the computer that is used to run the software. To do so, use the single HDMI connector found on the connector panel. Depending on the graphics card of the computer, you may need to use an HDMI-DVI cable or an HDMI-DVI adapter.

  • USB:
    Cornerstone sends control signals to the Cell via USB. The single USB connector in the connector panel must be connected to an available USB port on the computer.

  • Power and RCA Connectors:
    The power connector on the connector panel must be plugged in. Note that the Multitouch Cell is fully operational without the RCA connected.